Filter
Top Products
Settings
Y
our Detector
Nothing Comes Close to a Cobra
®
23
Settings
Y
our Detector
22
English
SmartPower Mode
Your detector includes the SmartPower feature that, when turned On, will put the
unit into Low Power mode 15 minutes after the car’s engine has been turned Off.
Before SmartPower enters Low Power mode, you will hear three beeps and
SmartPower will flash on the display. To return the unit to Normal Power
mode and exit Low Power mode, start the car, press any button or turn
the unit Off and then On again. The factory setting is SmartPower On.
Speed Units
If an Optional GPS Locator unit is installed, you can select between mph and
km/h as the units of speed to be displayed. The factory setting is mph.
Restore Factory Settings
From the Restore Factory Settings screen, you can quickly and
conveniently restore your detector to its original settings. Confirmation
messages are provided during the process.
SmartPower
Entering Low Power
Mode (Flashing)
Alert Settings
•
Pop Alert
When Pop Detect mode is On, Pop radar signals will be detected and an alert
will be given. During the alert, the unit will continue to detect other signals.
The factory setting is Pop Detect Off.
X Band Alert
When X Band Detect mode is On, X Band radar signals will be detected and
an alert will be given. During the alert, the unit will continue to detect other
signals. The factory setting is X Band Detect On.
K Band Alert
When K Band Detect mode is On, K Band radar signals will be detected and
an alert will be given. During the alert, the unit will continue to detect other
signals. The factory setting is K Band Detect On.
Ku Band Alert
When Ku Band Detect mode is On, Ku Band radar signals will be detected and
an alert will be given. During the alert, the unit will continue to detect other
signals. The factory setting is Ku Band Detect Off.
VG-2 Alert
The detector is undetectable by VG-2 detection devices and can alert you when
such a device is in use near your vehicle. When
VG-2 Detect mode is On, VG-2
signals will be detected and an alert will be given. During the alert, the unit will
continue to detect other signals. The factory setting is VG-2 Detect Off.
VG-2 Audio Mode
When VG-2 Audio mode is On, alerts will be sounded as well as being
displayed on the screen. This setting is only available if VG-2 Alert is On.
The factory setting is VG-2 Audio Off.