Filter
Top Products
To Turn On the Unit and Adjust the Audio Volume
Rotate the On-Off/
Volume control
clockwise (away
from you).
Tone
Visual Display
Voice
Three beeps Testing
System Ready
The display will then
cycle through the user
mode settings (city or
highway, Intellimute
and SmartPower
status).
Testing, then three
beeps
System Ready
Voice Alert
Start-up is complete when the display shows – – h.
Important: Once the compass is calibrated, the dashes will change
to one of the cardinal compass directions (N, NE, E,
SE, S, SW, W, NW). See page 18 to calibrate the compass.
Getting Started
Getting Started
•
Your Detector
Nothing Comes Close to a Cobra
®
5
Installation
Your Detector
4
English
Dashboard Mounting
System Ready
Voice Alert
Power On
Testing
NOTE
In some vehicles, power is supplied to the cigarette
lighter even while the ignition is Off. If this is the case with
your vehicle and you have turned the SmartPower Off, you
should turn Off or unplug your detector when parking for
lengthy periods. Cobra recommends leaving SmartPower
at the factory setting, which is On.
Start-Up Complete
__
h
1. Place the detector on the dashboard to find a location
where the unit has a clear, level view of the road.
The angle can NOT be adjusted after mounting.
2. Remove the paper backing
from one side of the hook-
and-loop fastener.
3. Attach the pad to the
dashboard at your chosen
location and remove the
other paper backing.
4. Attach the detector to the
hook-and-loop fastener.
You can remove and reattach
the unit as
often as you like.
5. Plug the power cord
into the detector.
6. Plug the cigarette lighter
adapter on the power
cord into your vehicle’s
cigarette lighter.
On-Off/
Volume Control
Rotate clockwise
(away from you)
XRS9770_MANL.indd 4-5 8/30/10 8:39 AM