Filter
Top Products
Nothing comes close to a Cobra
®
17
Settings
Y
our Detector
16
English
Compass
Your detector includes an internal
8-point
Compass that will continuously
display your current direction of travel:
N, NE, E, SE, S, SW, W, or NW.
Calibrating The Compass
NOTE
Before using it for the first time, you must calibrate the compass to
provide accurate indications of direction. See page 7 for instructions
on using the Program mode to select Set Compass.
Calibration allows the compass electronics to measure and store
information about the magnetic fields generated by your vehicle.
The compass will remain accurately calibrated as long as your detector is
mounted in the same place in your vehicle. If you change the location where
the unit is mounted or move it to another vehicle, you must recalibrate the
compass.
The compass temporarily may not provide accurate readings if you are inside
a building or enclosure, or are close to a large metal tractor/trailer, truck, or
train. Once you are away from such a location, the compass will work
correctly again.
NOTE
When the instructions direct you to drive in two (2) circles, a large
parking lot is the most convenient place to do so. It does not matter
what direction your vehicle is pointing when you start the circles, which
direction you go to make the circles, and it does not have to be exactly
two (2) circles. You do NOT have to make perfect circles. You can drive
in any pattern, as long as you make two (2) complete turns. Four (4)
three-point turns, two (2) small squares, or any two (2) complete loops
will work as well as two (2) circles. It does not matter what size the
circles are, if your speed is constant, or how fast you make the circles
[but less than two (2) minutes]. Please be careful when making the
circles and watch for other traffic.
8-Point
Compass
N
S
W
NW
SW
E
NE
SE
Program/Mute Button
Select/Dim Button
Set/City
Button
Settings
Y
our Detector
Tone Visual Display Voice
One (1) beep IntelliMute not set
Please try again
IntelliMute not set
Please try again
One (1) beep IntelliMute Off IntelliMute Off
NOTE
If the unit is unable to sense usable pulses within three (3)
seconds or if you do not set a rev point within 20 seconds
of beginning these steps, IntelliMute will indicate an error
and automatically turn off.
IntelliMu...
Please tr...
IntelliMute
Not Set
Setting IntelliMute RRMs
Intelli
Mute
Off
IntelliMute Off
To Set The IntelliMute Activation Point Using Program Mode
(See Page 7 For Instructions On Using Program Mode)
In Program mode, go to Set
IntelliMute.
Tone
Visual Display Voice
None Set IntelliMute None
Press and release the Set/City button
to begin setting IntelliMute RPMs.
Two (2)
beeps
Press SET
at desired
RPMs…
Set Engine
Revs
Rev your engine to the level you wish to
set. Rev the engine slightly above idle and
hold revs steady for two (2) seconds.
None None None
At the desired rev level, press and
release the Set/City button.
Three (3)
beeps
IntelliMute
Set!
IntelliMute
Set
Press and release either the
Select/Dim button to proceed to the
next user mode or the Program/Mute
button to exit the Program mode.
None None None
Set Intel... PressSET... Intelli
Mute
Set!