Filter
Top Products
Settings
Intro Operation Customer
A
ssistance
Warranty
N
otice
Secondary Icons
Your Detector
Nothing Comes Close to a Cobra
®
23
Settings
Intro Operation Customer
A
ssistance
Warranty
N
otice
Secondary Icons
Your Detector
22
English
DigiView Data Display Brightness
Your detector has a Bright display mode (for daytime driving) and three levels
of
Dim display modes (Dim for dusk driving, Dimmer for night driving and
Dark where no visual alerts will be displayed) to control the display’s
brightness levels. The factory setting is Bright. The factory Dim mode
default setting is Dimmer.
Select/Dim Button
Press and release
Dark Indicator
.
To Change the Brightness to Dim
Press and release the
Select/Dim button once.
Tone
Visual Display
Two beeps Dim, Dimmer or Dark
To Change the Brightness to Bright
Press and release the
Select/Dim button again.
Tone
Visual Display
One beep Bright
NOTE
When you change to Dim mode, the unit will enter
whichever dim default mode is set at the time.
Intro Operation Customer
Assistance
Warranty
Notice
M
ain Icons
Secondary Icons
Dim Display
Dim
Bright Display
Bright
Dimmer Display
Dimmer
Dark Display
Dark
SmartPower
Your detector includes the SmartPower feature that, when activated, will put
the unit into Standby mode (low power) for about 30 minutes after the car’s
engine has been turned Off. After 30 minutes in Standby mode, the unit will
automatically turn Off.
Before SmartPower enters Standby mode, you will hear one
beep and
Pwr Save will appear on the display. To return the
unit to normal Power mode or exit Standby mode, start the
car, press any button or turn the unit Off and then On again.
The factory setting is SmartPower On.
SmartPower Entering
Standby Mode
Pwr Save
SmartPower On
...Power On
SmartPower Off
...Power Off
To Turn SmartPower Mode On or Off Using Program Mode
(See Page 7 For Instructions on Using Program Mode)
In Program mode,
go to SmartPower.
Tone Visual Display
Two beeps SmartPower On
One beep SmartPower Off