Filter
Top Products
Voice/Tone Setting
You can set your detector to sound alerts with either a Voice or a Tone. You
can change settings by using the Mute button. In Voice Alert mode, you will
first hear several tones, then a voice message announcing the type of signal
detected, followed by more tones. In Tone Alert mode, you will hear the tones
only. The factory setting
To Turn VG-2 and Spectre I & IV+ Alerts On and Off
While no signal
is being detected,
press and hold the
Dim button for
four seconds.
Tone Voice
Visual Display
On = Two Beeps Spectre VG-2 On
V will blink twice
in the display
Your Detector
Nothing Comes Close to a Cobra
®
13
Settings
Your Detector
12
English
To Change From Voice Alert to Tone Alert
While no signal
is being detected,
press and hold
the Mute button
for two seconds.
Tone Voice
Visual Display
One beep Tone Alert None
To Change From Tone Alert Back to Voice Alert
While no signal
is being detected,
press and hold the
Mute button for
two seconds again.
Tone Voice
Visual Display
None Voice Alert None
Spectre VG-2 Off
V will blink once
in the display
Off = One Beep
VG-2 and Spectre I & IV+ Alert Settings
Police use radar detector detectors (RDDs) to spot users of radar detectors.
Your detector is able to identify signals from VG-2, Spectre I and Spectre IV+
RDDs and can provide alerts when any of these or similar devices are in use
near your vehicle.
Your detector can be spotted by Spectre IV+ RDDs, but is invisible to VG-2
and Spectre I RDDs. You can choose whether you want to be alerted to VG-2
and Spectre I & IV+ RDD signals. The factory setting for VG-2 and Spectre I &
IV+ alerts is Off.
IntelliMute Pro
IntelliMute Pro prevents detection by radar detector detectors (RDDs) such as
VG-2, Spectre I and Spectre IV+ when traveling at slower speeds. It is intended
for use by experienced users only.
When IntelliMute Pro is turned On, and engine RPMs are below the IntelliMute
activation point, your detector’s radar detection circuits are turned Off to
prevent detection by RDDs.
Before IntelliMute Pro can be turned On, you must have turned On and Set the
IntelliMute activation point. (See pages 9 through 11.)
To Turn IntelliMute Pro On
While no signal
is being detected,
press and hold both
the IntelliMute
and City buttons
for four seconds.
Tone Voice
Visual Display
Two beeps IntelliMute Pro On c or h will blink
To Turn IntelliMute Pro Off
Press and hold both
the IntelliMute and
City buttons for
four seconds.
Tone Voice
Visual Display
One beep IntelliMute Pro Off c or h will show
steady
IntelliMute Pro On
X K Ka V S
c
CAUTION
When IntelliMute Pro is On, NO radar signals will be detected and
NO alerts will be given at RPMs below the IntelliMute activation point.
IntelliMute Button
City Button
Press and hold both
buttons simultaneously
Settings
XRS9470_MANL.indd 12-13 8/20/10 8:42 AM