Filter
Top Products
Dim Button
Press and r elease
City Button
Press and
release
Settings
Your Detector
Nothing Comes Close to a Cobra
®
7
UltraBright Data Display Brightness
You can choose from three settings for Brightness of the display.
You can cycle through the settings by repeatedly pushing the Dim button.
The factory setting is Bright.
Settings
Your Detector
6
English
Highway/City Mode
Setting your detector to City mode delays all X band audio alerts until
the signal strength reaches Level 3. (A single beep will sound when the
signal is first detected.) This will reduce false alerts while you are driving
in, or near, urban areas where there are many sources for conflicting
X band signals such as microwave towers and automatic door openers.
To change settings, follow the procedure listed below, which indicates
what you will see and hear (either in Voice Alert or Tone Alert mode)
as you complete each step. The factory setting is Highway mode.
Bright
Dark
Dim
Press and
release Dim
button
City Mode
XKKaVS
c
Highway Mode
XKKaVS h
To Change From Highway Mode to City Mode
Press and release
the City button.
Tone Voice
Visual Display
One beep City
c
appears
in the display
To Change From City Mode Back to Highway Mode
Press and release
the City button again.
Tone Voice
Visual Display
Two beeps Highway
h
appears
in the display
To Change the Brightness to Dim
Press and release
the Dim button
once.
Tone Voice
Visual Display
One beep Dim Display dims
To Change the Brightness to Dark
Press and release
the Dim button
again.
Tone Voice
Visual Display
One beep Dark Display remains
dim (no visual
alerts will be seen)
To Change the Brightness to Bright
Press and release
the Dim button a
third time.
Tone Voice
Visual Display
Two beeps Bright Display returns
to full brightness
Settings
•
When changing the Settings on your detector, please keep in mind:
■
Buttons can have multiple functions.
■
Depending on your choice of Voice Alert or Tone Alert mode, you will
hear either voice messages or tones confirming changes in settings.
■
All settings will be stored in memory when the power is
turned Off and recalled when the power is turned back On.