Filter
Top Products
Quick Start
8
Turning On
Weather and
Changing
Stations
Quick Start
9
PRESS &
RELEASE
City/
Wx
Turning on Weather and Changing Stations
Press and release Wx button to activate
weather radio.When activated the Wx LED will
come on and the unit will announce “Weather On”
in Voice Mode or signal two beeps in Tone Mode.
If no station is heard, press and release
CITY/Wx button to step through the
10 channels until a station is received and the
Wx LED stays lit.The WxLED acts like a signal
strength meter for the weather radio.When
the signal is strong, the Wx LED will stay lit. If
the station signal weakens, the Wx LED will
flicker or if the signal is completely lost, the
ESD-9220 WX will go into Radar Mode. When
a station cannot be received, the unit will
announce “Weather Signal Lost”in Voice Mode
or signal one beep in Tone Mode and the Wx
LED will turn Off.
Press and release Wx button again to turn off
weather radio.When deactivated the unit will
announce “Weather Off”in Voice Mode or
signal one beep in Tone Mode.
1
2
3
Press WX button again for more than
2 seconds to turn off Weather Alert. When
deactivated the unit will announce “Weather
Alert Off”in Voice Mode or signal one beep in
Tone Mode and the Wx LED will stop blinking.
1
2
Set Weather
Alert
Set Weather Alert
Press WX button for more than 2 seconds to
activate Weather Alert.When activated the unit
will announce “Weather Alert On”in Voice Mode
or signal two beeps in Tone Mode.When in Wx
Alert On Mode, the Wx LED will blink slowly, even
though you do not hear the weather radio. If a
Weather Alert is received,“Weather Alert On” will
be heard in Voice Mode and then the Weather
Station broadcast will be heard telling you about
the severe weather.
Caution: Weather Alert will only operate if a Weather Station
is being received and the WxLED is blinking.If the Wx LED
stops blinking,you cannot receive a Wx Alert. If you have
not received a weather station for 1 minute,“Weather Signal
Lost”will be announced in Voice Mode or one beep will be
heard in Tone Mode and the Wx LED will stop blinking.
The ESD-9220 WX however,will still monitor for that station
to return. If, after 5 minutes the station is not received,
“ Weather Alert Off”will be heard and the ESD-9220 WX will
stop monitoring.Weather Alert can then be reset by turning
on the Weather Radio and finding a different weather station.
Note
Both Weather On/Off and
Weather Alert On/Off
settings,including the last
station you were listening to,
are retained in memory even
when unit is turned OFF.
Note
Factory default setting is
Weather Off and Weather
Alert Off Mode.
Note
If you try to turn on Weather
Alert and no station can be
received, the unit will not go
into Weather Alert Mode and
announce “Weather Alert Off”
in Voice Mode or one beep
will be heard in Tone Mode
and the Wx LED will not blink.
City/Wx
PRESS &
HOLD
City/
Wx