Filter
Top Products
3
OPERATION•SETTINGS
3
OPERATION•SETTINGS
13
12
N
S
EW
E
S
W
N
N
S
EW
S
W
N
N
S
EW
S
W
N
S
EW
N
E
N
S
EW
W
N
E
S
N
S
EW
Compass
Your ESD-9160 includes an internal 8-point
compass that will continuously display your
current direction of travel: N, NE, E, SE, S,
SW, W, or NW.
Calibrating the Compass
Important: Before using it for the first
time, you must calibrate the compass to
provide accurate indications of direction.
Calibration allows the compass electronics to
measure and store information about the
magnetic fields generated by your vehicle.
The compass will remain accurately calibrated
as long as your ESD-9160 is mounted in the
same place in your vehicle. If you change the
location where the unit is mounted or move it
to another vehicle, you must recalibrate the
compass.
The compass temporarily may not provide
accurate readings if you are inside a
building or enclosure, or are close to a large
metal tractor/trailer, truck, or train. Once
you are away from such a location, the
compass will work correctly again.
1.
NOTE: If you do not press
the CITY button the second
time within 60 seconds,
compass calibration will
automatically terminate.
Procedure
Press and hold
the CITY button for
at least 2 seconds.
Tone
1 beep
Visual Display
directional display
begins flashing
clockwise
Tone
3 beeps
Visual Display
directional display
flashes twice, no
direction of travel
is shown
2.
Procedure
Within 60 seconds,
drive your vehicle in a
circle twice, then press
the CITY button again.
Tone
2 beeps
Visual Display
directional display
flashes twice,
then shows the
direction of travel
N
S
EW
N
E
S
W
N
S
EW
VG-2 Alert
®
Audio Setting
The ESD-9160 is undetectable by police
VG-2 detection devices, and will alert you
when such a device is in use near your
vehicle. During the alert, the unit continues
to detect other signals. You can choose
whether or not you want your unit to
sound VG-2 alerts.
The factory setting is VG-2 Audio On.
X K Ka
V
/
S
N
S
EW
DIM button
Press and hold for 2 seconds
To turn off
VG-2
audio alert
To turn on
VG-2
audio alert
Procedure
While no signal is
being detected,
press and hold
the DIM button
for two seconds.
While no signal is
being detected, press
and hold the DIM
button for two
seconds again.
Tone
1 beep
2 beeps
Visual Display
V/S
will blink
once in
the display
V/S
will blink
twice in
the display.