Filter
Top Products
Additional/Replacement
Radio Keys
3. Wait for 10 seconds before inserting
the new battery, ensuring the correct
polarity (+ sign upwards) and holding
the battery by the edge.
4. Close the case firmly making sure
locating studs are correctly positioned
to ensure a waterproof seal is made.
5. The remote key should now operate
normally, but it may require re-
synchronisation with the main control
unit.
If, at any time, the remote key does not
operate the system, stand close to the car
and press and hold down both buttons
until the LED on the remote key goes out -
approximately 10 seconds. Release both
buttons - the LED will come on constantly.
Then press button A' for approximately 1
second - the LED will flash - this should
complete re-synchronisation. In case of
difficulties please consult your Cobra
Dealer.
The emergency override touch key can be
used to disarm/de-immobilise your Cobra
8165 Alarm System in the event of lost or
damaged radio keys. If your car is locked
use your door key to enter the car and
touch the Emergency Override Touch Key
on the contacts of the touch receptacle -
this will disarm and de-immobilise the
security system if this optional feature has
been selected. If the system was fully
armed' the siren will sound until
disarming has taken place. The car can
then be started in the normal way.
Optional Emergency
Override Touch Key
Testing Remote Key &
Re-synchronisation
l Up to four Emergency Override Touch
Keys can be programmed into each
Cobra 8165 Alarm System.
The radio keys for your Cobra 8165 Alarm
System have a protected self-learning'
feature which allows up to four Radio Keys
to be programmed into your system by
using its unique PIN code in conjunction
with the electronic touch keys.
All existing radio keys and touch keys
must be re-programmed at the same time
as any additional or replacement keys are
being introduced to the system. Your
Cobra Dealer will be able to carry out this
procedure for you.
Radio Key - pressing the operating button
A' will arm the system, indicated by:-
1. Two flashes of the vehicle's hazard lights.
2. Continuous flashing of the LED
warning light.
3. Simultaneous locking of all doors.
l Immediately the alarm unit is switched
ON (armed') the vehicle is immobilised
(optional).
After switching ON (armed') a period of
approximately 45 seconds will elapse
before the system is fully active. (This is a
setting-up' and test period').
When the alarm is fully active it will be
triggered by:-
1. Opening a door, boot or bonnet (Direct
Contact Switches).
2. Movement within the vehicle
(Ultrasonic or optional Microwave).
Arming the System
3