Cobra Electronics 7750 GPS Receiver User Manual


 
Start Up
IMPORTANT!
It is the user’s responsibility to account for the vehicle’s height,
width, length, HAZMAT, and other restrictions while driving.
Always follow posted road signs and be aware of road conditions
when making driving decisions.
Please read the “Important Safety Information” included with
your unit.
Power Key
SD Card Slot
External Speaker Jack
Mini USB Port
Power Adapter Jack
Reset Button
To charge the unit, connect either the AC
or DC Power Adapter. The battery light will
illuminate and will take approximately 3
hours to charge. When battery is fully
charged, the red LED will turn green. Once
fully charged the battery will last
approximately 2 hours during normal use.
NOTE: Turn the unit ON or OFF by pressing the Power Key for 2 seconds.
Mount the Unit
You can mount your 7750 Platinum to the inside of your vehicle’s
windshield using the windshield bracket provided.
• Clean the area where you wish to
position the bracket thoroughly with
glass cleaner.
• Assemble the suction cup bracket.
Slide the mount clip onto the end of the
suction cup arm and tighten both
plastic nuts.
• Place the suction cup and bracket on
the windshield and push the locking
lever towards the windshield to secure
the bracket.
• Adjust the angle of the bracket so that
when the unit is attached to it you
can view the display and operate the
controls safely.
• Do not place the mount in an airbag deployment area.
Slide the mount clip onto the end of the
NOTE: Mounting your 7750 Platinum in close proximity to a CB radio may
interfere with GPS reception. Should you encounter such interference,
position your 7750 Platinum as far away from your CB radio as possible.
Printed in China Part No. 480-669-P Version B
7750PLT_QSG_vB.indd 2 6/17/10 4:56 PM