Filter
Top Products
Feature
Factory
setting
# of
momentary
presses
Secondary
action
Program
completion
confirmation
Result
Add a new
remote to
channel 2
(optional
remote
accessory)
—
12
Press remote control button 2 2 chirps
Button 2/channel 2 code
of the new remote control
has been memorized
Add a new
remote to
channel 3
(silent
arm/disarm)
—
13
Press remote control button 3 3 chirps
Button 3/channel 3 code of
the new remote control
has been memorized
Add a new
remote to
channel 4
(optional
remote
accessory)
—
14
Press remote control button 4
of the optional
4-button/12-channel ACG
remote control
4 chirps
Button 4/channel 4 code
of the new remote control
has been memorized
Erase all
channels
—
15
— 2 chirps
All remote control codes
have been erased; program
in new remote control(s)
Valet code
See Setting your own secret valet code on page 12.
Set channel
4 timer
✱
30sec.
17
When the desired interval has
passed, turn off the ignition key
1 chirp
Timer has been set to the
interval of your choice
between 1sec. and 2min.
Example : To change the AutoArming feature from its factory
setting of “on” to “off,” you would do the following:
• Turn the ignition key to the ON position.
• Enter your valet code, then immediately tap and release the
momentary side of the PlainView switch 4 times (you’ll hear a chirp
each time you press to help you count to the total of 4 chirps).
• Wait 3 seconds. The system will sound one more chirp to confirm
that the AutoArming setting is now off (1 chirp = off, 2 chirps = on).
• Turn the ignition off. That’s all there is to it! To change the
AutoArming setting back, just repeat the procedure.
✱WARNING: If the built-in timer controls window/sunroof closure on your vehicle,
DO NOT change the timer setting! This requires installer-only programming.
18