Filter
Top Products
What each button/channel does
Your IntelliVoice-IQ remote controls come pre-programmed so that certain channels
command certain functions. If you wish, you can actually assign any channel except 9
through 12 to any function (see pages 17-21). The following chart indicates what each
remote control channel number does, and how to transmit each channel number.
Factory settings of the 12 remote control channels
Transmitting
channel
number:
Causes the system to:
Press the
LevelShift
button?
How
many
times?
Press
button
number
1
arm or disarm and lock or unlock the doors no — 1
2
pop the trunk* (if the system is disarmed)
AND
turn on the headlights* (if the system is armed)
no — 2
3
silently arm or disarm no — 3
4
activate optional accessory function #1 no — 4
5
switches between voice and chirp confirmations (see page 15) yes once 1
6
activate optional accessory function #3 yes once 2
7
activate optional accessory function #4 yes once 3
8
activate optional accessory function #5 yes once 4
9
remotely enter or exit valet mode (see pages 13) yes twice 1
10
remotely override the inner Proximity Sensor zone (see page 13) yes twice 2
11
remotely adjust sensitivity of the Proximity Sensor’s
passenger compartment zone (see page 13)
yes twice 3
12
remotely adjust sensitivity of the Proximity Sensor’s
exterior warning zone (see page 13)
yes twice 4
* May require additional wiring.
TO ARM
THE SYSTEM . . . . . . .
Press button 1 (channel 1) once. You will hear
“ARMED”
and
the parking lights will flash twice. The dashboard LED will flash
repeatedly and the car doors will automatically lock. NOTE: If
the system is set for chirps (see page 15), you will hear two chirps.
TO DISARM
THE SYSTEM . . . . . . .
Press button 1 (channel 1) again. You will hear “DISARMED”
and see one parking light flash. The doors will automatically unlock
and the interior lights will turn on and stay on for 30 seconds or
until you start the engine, whichever occurs first. NOTE: If the
system is set for chirps (see page 15), you will hear one chirp.
TO SILENTLY
ARM OR DISARM
THE SYSTEM . . . . . . .
Press button 3 (channel 3). Your IntelliVoice-IQ system will arm
or disarm with all the indications noted above except for the
voice/chirp acknowledgments.
8