Filter
Top Products
Adding new remote controls
For other drivers in your family, or if you wish to control Clifford systems on your
other cars with the same remote control, you can buy additional remote controls
from any Clifford Dealer (or call our Customer Service Department at
800-824-3208) and program them into the system yourself. Each Cyber 1 will
respond to as many as four 12-channel ACG remote controls. To add a new remote
control to the system, use the procedures noted in the User-selectable features
section on page 6.
How to erase the codes of lost or stolen remote controls
If one of your remote controls is ever lost or stolen, you can erase its digital codes
from the system memory to make sure that the missing remote control can never be
used to disarm your system. Just use the Adding new remote controls procedure
noted above for a total of four times (e.g., if you have one remote control remaining,
program it four times; if you have two remote controls, program each twice).
Example : To change the AutoArming feature from its factory
setting of “on” to “off,” you would do the following:
• Turn the ignition key to the ON position.
• Flick the valet switch back and forth 4 times (you’ll hear a chirp each
time to help you count to the total of 4 chirps).
• Wait 3 seconds. The system will sound one more chirp to confirm
that the AutoArming setting is now off (1 chirp = off, 2 chirps = on).
• Turn the ignition off. That’s all there is to it! To change the
Cyber 1 is covered by
one or more of the following Clifford Electronics patents:
4,158,874; 4,233,642; 4,327,444; 4,383,242; 4,430,685; 4,845,464;
4,887,064; 4,890,108; 4,922,224; 4,997,053; 5,081,667; 5,146,215;
5,157,375; 5,467,070 and other patents pending
© Copyright Clifford Electronics, Inc., 1996 31-085C/Cy1OM/896