Filter
Top Products
User-selectable features
Your ACE 500 vehicle security system allows you to set many of its features to
your own personal preferences. We have made the programming procedures very
simple: to make a change, you just flick the valet switch a few times. The system
comes from the factory with all of its features pre-programmed as noted in the table
below and on the next page. To change any of the settings, use the following
procedure. To restore the feature to its factory setting, just repeat the procedure:
1. Select the feature you wish to program from the table below and on the following
page. Note the number of flicks and chirps.
2. Turn your vehicle’s ignition switch to its “ON” position.
3. Immediately flick the valet switch back and forth, counting the number of chirps
you hear. Stop when you reach the number of chirps associated with the feature
you wish to program.
4. If noted, perform the “Secondary action.”
5. Wait 3 seconds. You will hear 1-5 chirps (as noted in the “Program completion
confirmation” column) and the LED will turn off. Turn the ignition off.
6. Repeat steps 1-5 for any other features you wish to program.
Feature
Factory
setting
# of
flicks &
chirps
Secondary
action
Program
completion
confirmation
Result
AutoArming
ON
4
—
1 chirp = OFF
2 chirps = ON
Change state from
ON to OFF or vice-versa
AutoArm
& Lock
OFF
5
—
1 chirp = OFF
2 chirps = ON
Change state from
OFF to ON or vice-versa
Chirp
confirmation
ON
6
—
1 chirp = OFF
2 chirps = ON
Change state from
ON to OFF or vice-versa
QuietChirps
OFF
7
—
1 chirp = OFF
2 chirps = ON
Change state from
ON to OFF or vice-versa
Headlight
Reminder
ON
8
—
1 chirp = OFF
2 chirps = ON
Change state from
ON to OFF or vice-versa
AutoLock &
AutoUnLock
ON
9
—
1 chirp = OFF
2 chirps = ON
Change state from
ON to OFF or vice-versa
Siren
duration
30 sec.
10
—
1 chirp=60sec
2 chirps=30sec
Change duration from 30 to
60 seconds or vice-versa
Tamper
Warning
OFF
11
—
1 chirp = OFF
2 chirps = ON
Change state from
ON to OFF or vice-versa
FACT
ON
12
—
1 chirp = OFF
2 chirps = ON
Change state from
ON to OFF or vice-versa
Add a new
remote to
channel 1
(arm/disarm)
—
13
Press remote control button 1 1 chirp
Button 1/channel 1 code
of the new remote control
has been memorized
continued . . .
15