Filter
Top Products
Feature
Factory
setting
# of
flicks &
chirps
Secondary
action
Program
completion
confirmation
Result
Add a new
remote to
channel 3
(silent
arm/disarm)
—
15
Press remote control button 3 3 chirps
Button 3/channel 3 code of
the new remote control
has been memorized
Add a new
remote to
channel 4
(optional
remote
accessory)
—
16
Press remote control button 4 4 chirps
Button 4/channel 4 code
of the new remote control
has been memorized
Add a new
remote to
channel 5
(remote
valet mode)
—
17
Press the side LevelShift
button once, then press
button 1
5 chirps
Button 1/channel 5 code
of the new remote control
has been memorized
Erase all
channels
—
19
— 2 chirps
All remote control codes
have been erased; program
in new remote control(s)
Adding new remote controls
For other drivers in your family, or if you wish to control Clifford systems on your
other cars with the same remote control, you can buy additional remote controls
from any Clifford Dealer and program them into the system yourself. Each ACE
300 will respond to as many as four 12-channel ACG remote controls. To add a new
remote control to the system, use the procedures noted in the User-selectable
features section on pages 13-14.
Example : To change the AutoArming feature from its factory
setting of “on” to “off,” you would do the following:
• Turn the ignition key to the ON position.
• Flick the valet switch back and forth 4 times (you’ll hear a chirp each
time to help you count to the total of 4 chirps).
• Wait 3 seconds. The system will sound one more chirp to confirm
that the AutoArming setting is now off (1 chirp = off, 2 chirps = on).
• Turn the ignition off. That’s all there is to it! To change the
14