Filter
Top Products
MS2004 Owner’s Manual - Page 7
To enter Panic Mode:
1. Press and hold Button 1 for 3 seconds.
• The siren will sound.
• The doors will unlock.
2. Press Button 1 again to stop panic and place system into the Armed state.
3. Press Button 2 to stop panic and place system into the Disarmed state.
If Panic Mode is not stopped by the Remote, it will automatically time out after 40 seconds, and
the system will return to its prior Armed/Disarmed state.
Coded Emergency Override
In case your Remote Transmitter becomes inoperable, or it is lost or stolen, you can still enter
and drive your car by using the following procedure. Be sure that you have your ignition keys
ready and that you know the location of the Override switch before you perform this procedure.
To override the system:
1. Unlock the door using the key.
2. Enter the vehicle.
• Because the system is armed, the system will trigger and the siren will be sounding.
3. Turn ignition key on.
4. Press the Override switch a number of times equal to the disarm code and continue
holding for 10 seconds on the last press.
• The system will disarm.
5. You can now start and drive the car.
6. If the disarm code is notentered correctly, turn off theignitionand begin againat step3.
Note: During installation, your installer can program the system to give 15 second entry delay when the system Arms
passively. When the door is opened while the system is Armed, the siren will give a series warning of chirps
before sounding, giving you time to perform the emergency override procedure.
Setting the Emergency Override/Disarm Code
The default setting for the Emergency Override Disarm Code is 1.
To change the Emergency Override Disarm Code:
1. Make sure the system is disarmed.
2. Turn the ignition key on.
3. Wait at least10 seconds.
4. Enter the desired disarm code then continue to hold the Override switch on the last
press for 10 seconds.
• The siren will chirp 3 times.
5. Release the switch.