Filter
Top Products
MOUNTING TO SLED
1.) INSERT OR ATTACH THE LYNCH PINS TO THE PIVOT BRACKETS AND HITCH ASSEMBLY.
2.) PLACE OR POSITION THE HITCH ASSEMBLY AT THE DESIRED MOUNTING LOCATION.
NOTE: Mounting height depends on the design of the sled base and therefore is subjective. We recommend
mounting as low as feasibly possible. However, before mounting, verify that there are no pivot obstructions
(such as the outside lip of the base) when mounted to the towing vehicle.
3.) MARK THE DRILL LOCATIONS USING THE MOUNTING HOLES OF THE PIVOT BRACKET AS A TEMPLATE.
4.) DRILL THE MARKED POSITIONS USING A 1/4" OR SLIGHTLY LARGER DRILL BIT.
5.) INSTALL THE HARDWARE AS SHOWN BEFORE SECURING FASTENERS.
TOWING LOADS SAFELY
• TRAVEL SLOWLY WHEN TOWING AND ALLOW EXTRA TIME AND DISTANCE TO STOP.
• TOTAL TOWED WEIGHT MUST NOT EXCEED LIMITS SPECIFIED IN TOWING VEHICLE’S OWNER’S MANUAL.
• REDUCE TOWED WEIGHT WHEN OPERATING ON SLOPES.
• NEVER ALLOW CHILDREN OR OTHERS IN OR ON TOWED EGUIPMENT WHILE TOWING.
• USE ONLY APPROVED HITCHES. TOW ONLY WITH A MACHINE THAT HAS A HITCH DESIGNED FOR TOWING.
• DO NOT ATTACH HITCH ASSEMBLY AT AN UNAPPROVED HITCH POINT.
• DO NOT TURN SHARPLY. USE CAUTION WHEN TURNING OR OPERATING UNDER ADVERSE CONDITIONS.
BACKING PLATE
(SHOWN FOR CLARITY)
PIVOT BRACKET
SLED BASE CUT-AWAY
LYNCH PIN