Cisco Systems 3040 Automobile Electronics User Manual


 
Corporate Headquarters:
© 2007 Cisco Systems, Inc. All rights reserved.
Cisco Systems, Inc., 170 West Tasman Drive, San Jose, CA 95134-1706 USA
Release Notes for the Cisco Catalyst
Blade Switch 3040 for FSC,
Cisco IOS Release 12.2(35)SE
January 8, 2007
Cisco IOS Release 12.2(35)SE runs on the Cisco Catalyst Blade Switch 3040 for FSC, referred to as the
switch. The switch is installed in the Fujitsu Siemens Computers (FSC) PRIMERGY BX600 system,
referred to as the BX600 system.
Note Before you install the switch in the BX600 system, upgrade the BX600 system management software to
version 1.68 or later for the switch to operate properly.
Check for updates to this document at this URL for information about compatibility with the BX600
system software:
http://www.cisco.com/en/US/products/ps6748/prod_release_notes_list.html
These release notes include important information about Cisco IOS Release 12.2(35)SE and any
limitations, restrictions, and caveats that apply to them. Verify that these release notes are correct for
your switch:
If you are installing a new switch, see the Cisco IOS release label on the switch packaging.
If your switch is on, use the show version privileged EXEC command. See the “Finding the
Software Version and Feature Set” section on page 4.
If you are upgrading to a new release, see the software upgrade filename for the software version.
See the “Deciding Which Files to Use” section on page 4.
For the complete list of Cisco Catalyst Blade Switch 3040 for FSC documentation, see the “Related
Documentation” section on page 19.
You can download the switch software from this site (registered Cisco.com users with a login password):
http://www.cisco.com/kobayashi/sw-center/sw-lan.shtml
This software release is part of a special release of Cisco IOS software that is not released on the same
8-week maintenance cycle that is used for other platforms. As maintenance releases and future software
releases become available, they will be posted to Cisco.com in the Cisco IOS software area.