Filter
Top Products
Section C
1) Connect the module, LED comes ON solid.
2) Turn key to ON position. LED will turn OFF. Module is now programmed.
VEHICLE PROGRAMMING:
MODE 1 =
MODE 8 = *OPTION 1: No reset (Default)
*OPTION 1: 1st pulse unlock all doors (Default)
OPTION 2: 1st pulse unlock driver door, 2nd pulse unlock all doors
OPTION 2: Complete reset of option and module
* = Default
USER SETTINGS - OPTIONAL PROGRAMMING:
USER MODES are identified by a slow LED flash pattern. 1 slow flash=Mode1, 2 slow flashes=Mode 2 etc.
Section D
NOTE: Only MODES 1 & 8 are available.
1) Key “OFF” position, press and hold program button for 2 seconds, LED will flash rapidly for 2 seconds. Release button, LED will identify the MODE
selection with a slow flash pattern (1- 8 slow flashes) and then will identify OPTION selection with a fast flash pattern. (1 or 2 fast flashes)
2) To change MODE, push button one time, LED will confirm MODE with slow flash pattern (1-8 slow flashes).
3) To change OPTION SELECTION within a MODE, press LOCK or UNLOCK button on the aftermarket remote control system. LED will identify option
selection with either one or two fast flashes.
4) To save and exit programming, press and hold button until LED flashes one time rapidly, showing end of OPTION programming.
Description: Chrysler Dodge Jeep Door Lock Alarm Interface (NO KEY REQUIRED)
Functions: Data Bus Interface: Lock/Unlock, Trunk/Rear Hatch, OEM Security Arm/Disarm, Starter Enable, Door Sense Trigger
Installation
Manual (2\2 Pages)
Platform #03 Firmware: CHDL7