Filter
Top Products
Description:
Functions:
Chrysler Sedan Door Lock Alarm & Interface: Intrepid (CHDL2) Door Lock & Alarm Interface (NO KEY REQUIRED)
Data Bus Interface: Lock/Unlock, Trunk, OEM Security Arm/Disarm
Installation Manual (2/ 2 Pages)
Platform # 03 Firmware: CHDL2
VEHICLE PROGRAMMING:
1)
2)
Connect the module, LED will goes on.
Turn key ON, LED will turn off. Module is now programmed.
Section C
MODE 7 =
MODE 8 = *OPTION 1: No reset (Default)
*OPTION 1: Vehicle alarm (Default)with
OPTION 2: Vehicle alarmwithout
OPTION 2: Complete reset of option and module
* = Default
USER SETTINGS - OPTIONAL PROGRAMMING:
USER MODES are identified by a slow LED flash pattern. 1 slow flash=Mode1, 2 slow flashes=Mode 2 etc.
Section D
NOTE: Only MODES 7 & 8 are available.
1) “OFF” press hold
2) MODE push button MODE
3) press LOCK or UNLOCK
4) press hold button
Key position, and program button for 2 seconds, LED will flash rapidly for 2 seconds. Release button, LED will identify the MODE
selection with a slow flash pattern (1- 8 slow flashes) and then will identify OPTION selection with a fast flash pattern. (1 or 2 fast flashes)
To change , one time, LED will confirm with slow flash pattern (1-8 slow flashes).
To change OPTION SELECTION within a MODE, button on the aftermarket remote control system. LED will identify option
selection with either one or two fast flashes.
To save and exit programming, and until LED flashes one time rapidly, showing end of OPTION programming.
#03-CHDL2
Chrysler Doorlock Alarm Interface
Data Bus Interface: Lock/Unlock, Trunk, OEM Security Arm/Disarm
TECH NOTES FOR VIOLET/WHITE WIRE
DO NOT ADD RESISTOR’S AS THEY ARE INTERNAL
DOORLOCKS/ALARM ACTIVATION WIRE
SEBRING SEDAN:
ALL OTHER MODELS:
White/Dark Green at BCM
Light Green/Orange at BCM
IMPORTANT:
*On Sebring and Stratus Coupes, you can control the alarm.
*On Sebring and Stratus Sedan, you control the alarm.
*Do not install module on a metal service.
NOT
CAN
Section F