Filter
Top Products
AM-FM Radio (Single Display,
Base Level)
Playing the Radio
O
(Power): Press this knob to turn the system
on or off.
u (Volume): Turn this knob to increase or to
decrease the volume. VOL will appear on the display.
Finding a Station
AM/FM: Press this button to switch between FM1, FM2,
or AM. The display will show the selection.
p (Tune): Turn this knob to select radio stations.
tu(Scan): Press this knob until SCAN flashes on
the display, then press either the up or the down arrow
buttons to determine the direction for the radio to scan
the stations. The radio will go to a station, play for a
few seconds, then go on to the next station. Press
either arrow button again to stop scanning.
The radio will only scan stations with a strong signal that
are in the selected band.
Setting Preset Stations
Up to 18 stations (six FM1, six FM2, and six AM) can
be programmed on the six numbered pushbuttons,
by performing the following steps:
1. Turn the radio on.
2. Press AM/FM to select FM1, FM2, or AM.
3. Tune in the desired station.
4. Press and hold one of the six numbered pushbuttons
for longer than two seconds. Ch will appear on the
display when the station has been set. Whenever
that numbered pushbutton is pressed, the station
that was set will return.
5. Repeat the Steps 1 through 4 for each pushbutton.
3-55