Chevrolet 2008 Avalanche Automobile User Manual


 
Heated Windshield Washer
For vehicles with the heated windshield washer fluid
system it can be used to help clear ice, snow, tree sap,
or bugs from your windshield.
The button is located in
the switchbank under the
climate controls.
Push the heated washer fluid button to activate the
heated windshield washer fluid system. The indicator
light will flash. This activation initiates four heated
wash/wipe cycles. The first heated wash/wipe cycle may
take up to 40 seconds to occur, depending on outside
temperature. After the first wash/wipe cycle, it may take
up to 20 seconds for each of the remaining cycles to
begin. Press the button again to turn off the heated
windshield washer fluid system or it will automatically
turn off after four wipe cycles have been completed.
When the heated windshield washer fluid system
is activated under certain outside temperature
conditions, steam may flow out of the washer nozzles
for a short period of time before washer fluid is sprayed.
This is a normal condition.
Cruise Control
{CAUTION:
Cruise control can be dangerous where you
cannot drive safely at a steady speed. So, do
not use your cruise control on winding roads
or in heavy traffic.
Cruise control can be dangerous on slippery
roads. On such roads, fast changes in tire
traction can cause excessive wheel slip, and
you could lose control. Do not use cruise
control on slippery roads.
With cruise control, you can maintain a speed of about
25 mph (40 km/h) or more without keeping your foot
on the accelerator. This can really help on long
trips. Cruise control does not work at speeds below
about 25 mph (40 km/h).
When you apply your brakes, cruise control is turned off.
If your vehicle has the StabiliTrak
®
system and begins
to limit wheel spin while you are using cruise control, the
cruise control will automatically disengage. See
StabiliTrak
®
System on page 4-6. When road conditions
allow you to safely use it again, you may turn the
cruise control back on.
3-11