© 2006, The Chamberlain Group, Inc.
114A3249 All Rights Reserved
Craftsman
®
is a Registered Trademark of Sears, Roebuck and Co.
INSTALLATION
1. Choose a convenient
location for
installation. Install out
of the reach of
children at a minimum
height of 5 feet
(1.5 m), away from all
moving parts of door.
For a one-piece door,
choose the optional
location shown in the
illustration to avoid
injury as the door swings up and out.
Test the reception of the Keyless
Entry by operating your opener
from the selected location.
Change the location if necessary.
2. Remove the compartment cover
to access the bottom mounting
hole. Slide the cover down to
remove. Remove battery.
3. Center the template on selected
location. Mark the top centerline
screw location and drill 1/8" pilot
hole. Install top mounting screw, allowing 1/8" to protrude
above surface. Position keyless entry on screw head and
adjust for snug fit. Drill 1/8" pilot hole for the bottom mounting
screw. Complete installation with bottom screw, using care to
avoid cracking plastic housing. Do not over tighten.
Reinstall battery and replace the compartment cover. To
replace compartment cover slide up and snap it into place.
TO CHANGE AN EXISTING, KNOWN PIN
If the existing PIN is known, it may be changed by one person
without using a ladder.
1. Press the four buttons for the present PIN, then press and
hold the # button.
The opener light will blink twice. Release the # button.
2. Press the new 4-digit PIN you have chosen, then press Enter.
The motor unit lights will blink once when the PIN has been
learned.
Test by pressing the new PIN, then press Enter. The door
should move.
TO SET A TEMPORARY PIN
You may authorize access by visitors or service people with a
temporary 4-digit PIN. After a programmed number of hours or
number of openings, this temporary PIN expires and will no
longer open the door. It can be used to close the door even
after it has expired. To set a temporary PIN:
1. Press the four buttons for your personal entry PIN (not the
last temporary PIN), then press and hold the ✽ button.
The opener light will blink three times. Release the button.
2. Press the temporary 4-digit PIN you have chosen, then press
Enter.
The opener light will blink four times.
3. To set the number of hours this temporary PIN will work,
press the number of hours (up to 255), then press ✽.
OR
3. To set the number of openings this temporary PIN will work,
press the number of times to open (up to 255), then press #.
The opener light will blink once when the temporary PIN has
been learned.
FOR SERVICE DIAL OUR TOLL FREE NUMBER:
1-800-528-9131
Test by pressing the four buttons for the temporary PIN, then
press Enter. The door should move. If the temporary PIN was
set to a certain number of openings, remember that the test
has used up one opening.To clear the temporary password,
repeat steps 1-3, setting the number of hours or times to 0 in
step 3.
SPECIAL NOTE: The temporary password can ONLY be
programmed to Keyless Entry working on a Chamberlain,
Craftsman
®
or LiftMaster Garage Door Opener. It WILL NOT
work on Keyless Entry programmed to an external receiver.
The temporary password will continue to CLOSE the door even
after the time has expired.
To eliminate this, program a new temporary password into the
Keyless Entry.
KEYLESS ENTRY MOUNTING
(For reference only.)
