Filter
Top Products
Q (Lock): Press to lock
the doors and arm the
theft-deterrent system.
See Theft-Deterrent
System on page 2-19 for
additional information.
If enabled through the Driver Information Center (DIC),
the exterior lamps may flash and/or the horn may sound
to indicate locking has occurred. You will not receive
feedback when locking the vehicle with the RKE
transmitter if the doors are open. See DIC Vehicle
Customization on page 3-60 for additional information.
K (Unlock): Press to unlock the driver door and
disarm the theft-deterrent system. Press
K again
within five seconds to unlock the rest of the doors.
If enabled through the DIC, the exterior lamps may
flash. You will not receive feedback when unlocking the
vehicle with the RKE transmitter if the doors are open.
See DIC Vehicle Customization on page 3-60 for
additional information.
/ (Remote Vehicle Start): Press to start the engine
from outside the vehicle using the RKE transmitter.
See Remote Vehicle Start on page 2-7 for additional
information.
L (Panic Alarm): Press and release to locate the
vehicle. The turn signal lamps flash and the horn sounds
three times.
Press and hold
L for more than two seconds to
activate the panic alarm. The turn signal lamps flash and
the horn sounds repeatedly for 30 seconds. The alarm
turns off when the ignition is turned to ON/RUN or
L is
pressed again. The ignition must be in LOCK/OFF for the
panic alarm to work.
& (Power Liftgate): Press and hold to open and
close the liftgate. The taillamps flash and a chime sounds
to indicate when the liftgate is opening and closing.
The vehicle comes with two transmitters. Each
transmitter will have a number on top of it, ‘‘1’’ or ‘‘2’’.
These numbers correspond to the driver of the vehicle.
For example, the memory seat position for driver 1
will be recalled when using the transmitter labeled ‘‘1’’,
if enabled through the DIC. See Memory Seat and
Mirrors on page 1-5 and DIC Vehicle Customization
on page 3-60.
With Remote Start
(Without Remote Start
Similar)
2-5