Filter
Top Products
Black plate (29,1)
Cadillac SRX Owner Manual (GMNA-Localizing-U.S./Canada/Mexico-
6081464) - 2014 - 1st crc - 6/3/13
Vehicle Care 10-29
6. Connect the electrical connector.
7. Install the cap with the down
arrow pointing down in the back
of the headlamp assembly.
8. For driver side, reinstall the
underhood electrical center
cover by latching three clips.
9. For passenger side, reinstall the
air filter/cleaner assembly base
by pushing to seat . Verify the
base is seated securely, then
install the engine air filter/
cleaner assembly.
Front Turn Signal Lamp (Base
and Uplevel)
To replace the front turn
signal lamp:
1. Remove the turn signal lamp
bulb socket from the headlamp
assembly.
2. Remove the turn signal lamp
bulb from the socket.
3. Replace the bulb in the bulb
socket.
4. Install the bulb socket in the
headlamp assembly.
5. For the driver side, reinstall the
underhood electrical center
cover by latching three clips.
6. For the passenger side, reinstall
the air filter/cleaner assembly
base by pushing to seat. Verify
the base is seated securely, then
install the engine air filter/
cleaner assembly.
Turn Signal Lamps
To replace one of these bulbs:
1. Open the liftgate. See Liftgate
on page 2-13.
2. Remove the push pin (1) on the
taillamp cover (2).
3. Remove the taillamp cover from
the lamp assembly by pulling
rearward from the top to
unfasten the snap tabs.