Filter
Top Products
If you have additional transmitters to program, this
process can be repeated until four transmitters have
been programmed. The DIC will then display MAX
# FOBS LEARNED and will exit the programming mode.
When you are done programming transmitters, press
the unlock button on each keyless access transmitter
twice. After performing this process, transmitters
previously programmed will no longer work with your
vehicle and must be reprogrammed.
Battery Replacement
Under normal use, the battery in your keyless access
transmitter should last about three years.
You can tell the battery is weak if the transmitter will not
work at the normal range in any location. If you have
to get close to your vehicle before the transmitter works,
it is probably time to change the battery. The DIC
may display KEY FOB BATTERY LOW.
A weak battery may also cause the DIC to display
NO FOBS DETECTED when you try to start the vehicle.
If this happens, place the transmitter in the center
console storage area transmitter pocket with the
buttons facing to the front of the vehicle. Then, with the
vehicle in PARK (P) or NEUTRAL (N), press the
brake pedal and the start button. See Starting the
Engine on page 2-25, for additional information about
your vehicle’s electronic keyless ignition with push
button start. Although this will start the vehicle, it is
recommended that you replace the transmitter battery
as soon as possible.
Notice: When replacing the battery, use care not to
touch any of the circuitry. Static from your body
transferred to these surfaces may damage the
transmitter.
To replace the battery, do the following:
1. Insert a coin or similar object into the slot on the
back of the transmitter and carefully pry apart the
front and back.
2. Carefully pull the battery out of the transmitter.
2-9