Filter
Top Products
SYSTEM FEATURES
One Piece Self-Contained Fast and easy to install, usually 5 to 10 minutes with no experience.
Only One Wire Fits virtually any vehicle.
Two Long Range Four Remotely activates alarm in chirp or voice mode. Slide protection stops
Button Remote Controls accidental alarm activation.
Extra Loud Siren Deters thief from further tampering.
Battery Back-Up (Optional) Alarm will continue to sound even with vehicle battery disconnected.
Current Sensing Alarm will sound with changes in current. EXAMPLE: Dome light or
ignition switch
Electronic Dual Will warn away without going into full alarm.
Stage Shock Sensor
Talking Alarm Demands authority and attention compared to non-talking alarms.
Instant Panic Mode Should you feel threatened you can remotely activate, with a press of the
remote transmitter, a woman’s voice shouting “Please Help Me” , and siren
sounding.
Remote Car Finder Helps you locate your vehicle in crowded parking lots by chirping the siren
8 times.
Automatic Alarm Reset If the alarm is violated, it will stop and rearm itself after 30 seconds.
Scan Deterrent Protects your car from scanning devices sometimes used by thieves to disarm
alarm systems.
Passive Arming Automatically arms the system one minute after the last door is closed.
High Theft Area When parking in potentially high theft areas, you may program your alarm to
say “system armed” every 30 seconds.
Limited Lifetime Warranty Guarantees life-long protection.
TECHNICAL ASSISTANCE
Should you need help. First check our website at www.bulldogsecurity.com/wires.htm or call our toll-free
Tech Support Hotline Monday through Friday 9AM-8PM and Saturday 10AM-4PM EST at 800-878-8007.
You must give the following information:
•Name
•Telephone Number with Area Code (Fax number if applicable)
•Year, Make, and Model of the vehicle
•The model number of the system you are installing
•The type of assistance you are requesting
If you give the above information you will be called back as soon as possible, usually within 10 minutes.
INSTALLATION INSTRUCTIONS
1
1. Locate a solid, well grounded metal surface under the hood. Any metal fender, firewall, or metal
plate will do. For the loudest sound, the siren should point down. CAUTION: Do not mount close to
exhaust or other high temperature areas. Make sure the alarm as well as the metal it's mounted
to is solid with no moving parts nearby. The siren should not point straight up, as moisture could
collect in the siren horn and damage the system. (See figure #1)
2. Use three self-tapping screws (included) to secure alarm. Screw into a well grounded metal surface.
CAUTION: You must use all 3 screws. (See figure #2)