Filter
Top Products
SYSTEM FEATURES
One-Piece Self-Contained Fast and easy to install, usually 5 to 10 minutes with no experience. Fits virtually any
Only One Wire vehicle.
Long Range Four Button Remotely activates your alarm. Slide protection stops accidental alarm activation.
Remote Transmitter
Extra Loud Siren Deters thieves from further tampering.
Current Sensing The alarm will sound with changes in current. Example: Dome light or ignition switch.
Electronic Will warn away without going into full alarm activation.
Dual Stage Shock Sensor
Instant Panic Mode Should you feel threatened, you can remotely activate the siren with the press of a button.
Remote Car Finder Helps you locate your vehicle in a crowded parking lot by chirping the siren eight times.
Automatic Alarm Reset If the alarm is violated, it will stop and rearm itself after 30 seconds.
Special Situations Allows you to lower or shut off the sensitivity of your shock sensor for special situation.
Example: when parked near a construction zone or in heavy rain. (Remotely programmable)
Limited Lifetime Warranty Guarantees life-long protection.
TECHNICAL ASSISTANCE
Should you need help. First check our website at www.bulldogsecurity.com/wires.htm or call our toll-free
Tech Support Hotline Monday through Friday 9AM-8PM and Saturday 10AM-4PM EST at 800-878-8007.
You must give the following information:
•Name
•Telephone Number with Area Code (Fax number if applicable)
•Year, Make, and Model of the vehicle
•The model number of the system you are installing
•The type of assistance you are requesting
If you give the above information you will be called back as soon as possible, usually within 10 minutes.
1. Locate a solid, well grounded metal surface under the hood. Any metal fender, firewall or metal plate
will do. For the loudest sound, the siren should point down. CAUTION: Do not mount close to exhaust or
other high temperature areas. Make sure the alarm as well as the metal it is mounted to is solid with
no moving parts nearby. The siren should not point up, as moisture could collect in the siren horn
and damage the system (See figure #1.)
2. Use three self-tapping screws (included) to secure the alarm. Screw into a well grounded metal surface.
CAUTION: You must use all three screws. (See figure #2.)
3. Connect the RED power wire with the supplied alligator clip and clip it to any constant +12 volt supply
such as the battery. If installation is correct, the alarm will chirp three times. (See figure #3.)
4. For maximum range, keep the YELLOW antenna wire straight and as far away from metal as possible.
INSTALLATION INSTRUCTIONS
1
Antenna
Self-tapping
screws
Alarm
- +
To Alarm
Red
Positive
Cable
Figure 3Figure 2Figure 1
Possible
Locations