Filter
Top Products
Active Holder
for Fixed Installation
New improved charger
The 2nd Generation Molex active holder has
now been released. The charger has many
improved features, such as
- New overmoulded connector
- Improved protection against peaks
- Built-in resettable fuse in the box (2 A)
- Improved overload protection
- New box design, with ventilation holes
- More efficient charging, generates less heat
The product is CE and E approved.
Connect the power cable with a 2 A fuse.
5 Volt out.
2 A charger.
12/24 Volt.
Professional installation recommended.
2nd Generation
With Molex adapter system
An active holder with a straight cable with
open end for fixed installation and a cable with
Molex adapter system. The cables are to be
connected inside the dashboard, this gives a
discreet, neat installation without cables
hanging over the interior.
You can choose to use the holder as an active
holder only for charging, or to connect an
adapter to the Molex connector for additional
features. Then you can use the holder also for
power supply of a GPS receiver or other own
solutions. Can not be used for data comm-
unication
The holder is attached onto a tilt swivel so it
can be adjusted in order to avoid light
reflection. Attach onto the ProClip Mounting
Platform.