Filter
Top Products
12
Adding Fuel
1. Remove cap. Fill tank to approximately one inch
below top of neck to allow for fuel expansion. Be
careful not to overfill.
2. Replace cap before starting.
Fuel Fill
• Turn engine OFF and let engine
cool at least 2 minutes before
removing gas cap.
• Fill fuel tank outdoors or in
well-ventilated area.
• Do not overfill fuel tank. Fill tank to
approximately 1 inches below top of
neck to allow for fuel expansion.
• If fuel spills, wait until it evaporates
before starting engine.
• Keep gasoline away from sparks,
open flames, pilot lights, heat, and
other ignition sources.
• Check fuel lines, tank, cap, and
fittings frequently for cracks or
leaks. Replace if necessary.
WARNING
Fresh StartE Fuel Cap
Your engine may be equipped with
a Fresh Start fuel cap.
Cartridge is shown with tab
partially removed.
Fresh Start fuel cap is designed to
hold a cartridge which contains fuel stabilizer.
1. Place silver foil seal end of cartridge into fuel cap.
2. Press to “snap” cartridge into place.
3. Remove the white tab to expose membrane.
4. Reinstall fuel cap on engine fuel tank.
5. Check periodically − if empty, remove and
replace.
DANGER
• IF SWALLOWED, call physician immediately.
Do not induce vomiting. If inhaled, remove to
fresh air. In case of eye or skin contact, flush
with water for 15 minutes.
• Store unopened cartridges in a cool, dry,
well-ventilated area. Keep open cartridge in
fuel cap, and fuel cap closed on fuel tank when
not in use.
Contents are HARMFUL OR FATAL IF
SWALLOWED. Avoid contact to eyes,
skin, or clothing. Do not take internally.
Avoid breathing the mist or vapor.
Overexposure to eyes or skin can
cause irritation. KEEP STABILIZER
OUT OF THE REACH OF CHILDREN.
Fuel stabilizer is a hazardous
chemical.**
** Fuel stabilizer contains: 2,6-di-tert-butylphenol (128-39-2)
and aliphatic petroleum distillate (64742-47-8).
• In case of emergency, contact a physician
immediately and call 1-800-424-9300 for material
safety information.