Filter
Top Products
IMPORTANT INFORMATION
••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••
MVM Instructions |
Page 1
IMPORTANT INFORMATION
Please read instructions completely before installing this Bracketron MVM Mount. All instructions are written from the drivers
seat vantage point looking forward at the vehicles dash. We advise caution whenever you are removing or handling plastic
parts of a vehicles dash. WARNING: Unnecessary force or pressure can cause pieces to crack or break.
PARTS INCLUDED: MVM-35-05 Mount, 3 - #8x3/4” Self Tapping Screws PHS-203 Ultra Slim Swivel and Hardware.
TOOLS NEEDED FOR MVM MODIFICATION (if required)
4 inch Mounted Bench Vise
12 oz. Ball Pein Hammer
Standard Tin Snips
Small File
TOOLS NEEDED FOR DASH PANEL DISASSEMBLY
Dash Trim Tool (Part #SIT-104)
9/32” Socket and Driver
9/32” Open End Wrench (for swivel)
Marking Pen
DASH DISASSEMBLY INSTRUCTION
••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••
Begin installation by removing the bezel with the two vents and surrounds
the radio display. Insert a Dash Trim tool (part #SIT-104) on the right side
of the bezel. Release two (2) clips on the right side, work your way to
the left side and release another two (2) clips. Note: You do not need to
disconnect any wiring.
Continue by removing the two (2) 9/32” screws on the top of the radio.
Set the screw aside in a safe place.
Skip to Step 6 on the following page if you have not yet formed the
MVM to fit your vehicle.
Next gently pry the top of the radio out just enough so you can get the
MVM to fit behind
. Slide the MVM in place and push the radio back in.
Replace the screws and tighten the mount down.
Carefully reinstall the dash in reverse order securing all screws and clips
to the bezel. Install the included Ultra Slim Swivel #PHS-203 to your Multi
Vehicle Mount or any other AMPs compatible device.
Your installation is complete
Install Mount Here
1
2
3
5
4
Note: The hole pattern on the face of the MVM maybe
different then what is shown in the pictures.