Filter
Top Products
IMPORTANT INFORMATION
••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••
MVM Instructions |
Page 1
IMPORTANT INFORMATION
Please read instructions completely before installing this Bracketron MVM Mount. All instructions are written from the drivers
seat vantage point looking forward at the vehicles dash. We advise caution whenever you are removing or handling plastic
parts of a vehicles dash. WARNING: Unnecessary force or pressure can cause pieces to crack or break.
PARTS INCLUDED: MVM-15-05 Mount, 3- #8x3/4” Self Tapping Screws PHS-203 Ultra Slim Swivel, and Hardware
TOOLS NEEDED FOR MVM MODIFICATION (if required)
There are no modifications required to the MVM mount
for this application.
TOOLS NEEDED FOR DASH PANEL DISASSEMBLY
Dash Trim Tool (Part #SIT-104)
# 2 Phillips Screwdriver
10mm Socket and Driver
Fiskars 8511 Craft Hand Drill (recommended)
5/64” Drill Bit
9/32” Open End Wrench (for swivel)
Marking Pen
DASH DISASSEMBLY INSTRUCTION
••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••
Start by applying the emergency brake. Insert the dash trim tool behind the
upper right corner of the radio trim bezel. Pry toward you to release the first
clip. Continue working around the bezel releasing a total of six clips. Set
the bezel aside. Remove four (4) 10mm bolts from the corners of the radio.
Carefully slide the radio out of its cavity and disconnect all the wiring. Set the
radio aside.
Locate the flat area on the right side of the cavity just below the middle clip
hole. Place the MVM over this flat area. Use the marking pen and the holes
in the MVM as a guide and mark two pilot holes. Remove the MVM and then
carefully drill two pilot holes using a 5/64” drill bit and hand drill. Place the
MVM back over the pilot holes. Insert the provide screws and tighten with a
number 2 Phillips screwdriver.
Carefully reinstall the dash in reverse order securing all screws and clips
to the bezel. Install the included Ultra Slim Swivel #PHS-203 to your Multi
Vehicle Mount or any other AMPs compatible device.
Your installation is complete.
Install Mount Here
1
2
3
Note: The hole pattern on the face of the MVM maybe
different then what is shown in the pictures.
Mark & Drill Here
Use Dash Tool Here
Final Installation