Filter
Top Products
170n
Do not use spray starter fluids to start
the engine.
If the battery is discharged, the engine
can be started with the use of two
jumper cables and the battery of an-
other vehicle. Always use jumper ca-
bles with fully insulated handles on the
terminal clamps.
Do not touch the parts conducting
current while the engine is run-
ning. Failure to comply with this creates
a risk of fatal injury.<
Carefully comply with the following in-
structions to avoid personal injury and
damage to one or both vehicles:
1 Be sure that the battery on the sup-
port vehicle is also rated at 12 volts,
and that the capacities of the two
batteries (Ah) are roughly comparable
(printed on casing).
2 Leave your battery connected to the
vehicle's electrical system.
3 Make sure that there is no contact
between the bodywork of the two
vehicles – this creates a risk of short
circuits.
4 Start by connecting the jumper cable
from the positive terminal of the sup-
port vehicle to the positive terminal
connector located in your BMW's en-
gine compartment The cover of the
auxiliary terminal for jump starting is
marked with a "+" sign (refer to the il-
lustration). To remove the cover, tip
up the cap (arrow).
530us126
5 Then connect the negative terminals.
Attach the cable to either the support
vehicle's negative battery terminal (-),
or to a suitable ground on its engine
or bodywork. Then connect the other
end of the cable to a ground on the
engine or on the bodywork of the ve-
hicle that is to be started. There is a
special nut for this on the left side
panel of your BMW. Refer to the ar-
row in the illustration.
Follow the same sequence for
connecting the jumper cables
when helping other vehicles. If you do
not, there is the risk of injury if sparks
generate at the battery.<
530us127
Jump-starting
Online Edition for Part No. 01 41 0 155 303 - © 12/99 BMW AG