Filter
Top Products
Everything under control
78
The symbols also show the service require-
ments status, see page 74.
Messages displayed at end of a journey
Malfunctions which have been indicated during
a journey are displayed again when you switch
off the ignition.
You can call up the messages again provided
the display has not yet gone out. Press CHECK
button for approx. 2 seconds. If there are sev-
eral messages, press the CHECK button as
many times as necessary.
The display goes out
> Automatically after a short time
> If you press the CHECK button again for
approx. 2 seconds
Speed limit*
You can enter a speed at which you are to be
alerted by means of a Check Control message.
You can use this feature e.g. to ensure that you
do not exceed the speed limit in a built-up area.
A renewed reminder of this speed limit will not
be given unless you have undercut it by at least
5 km/h, approx. 3 mph, in the meantime.
Displaying, setting or altering limit
iDrive concept, see page 14.
1. Call up the start menu.
2. Call up "Navigation".
On cars without navigation system
*
: call up
"OBC".
3. Select "On-board Info" and press the con-
troller.
4. Select "Limit" and press the controller.
5. Select the speed and press the controller.
6. Turn the controller to adjust the limit. You
may need to overcome a slight resistance if
you wish to enter a relatively high differ-
ence.
7. Press the controller to adopt the setting.
The limit is automatically switched on.
Memorising actual speed as limit value
Select "Accept current speed" and press the
controller. The actual speed is memorised as
the limit value.
Activating limit
Select "On" and press the controller.
The limit is automatically switched on.
Stopwatch*
iDrive concept, see page 14.
1. Call up the start menu.
2. Call up "Navigation".
On cars without navigation system
*
: call up
"OBC".
3. Select "On-board Info" and press the con-
troller.
4. Select "Stopwatch" and press the control-
ler.
Starting, stopping or resetting
> Select "Start" and press the controller. The
stopwatch starts at the time displayed.
> Select "Reset" and press the controller.
The stopwatch is reset and starts again if it
was running previously.
Online Edition for Part-No. 01 41 0 159 725 © 09/05 BMW AG