Black Box LES1203A-11G Remote Starter User Manual


 
Remote Console Manager Quick Start Guide
724-746-5500 | blackbox.com
Page 4
Step 3: Set up the remote console manager.
The default remote console manager IP address is 192.168.0.1 (subnet
mask 255.255.255.0). With a Web browser on any computer that is
connected through the LAN to the serial device server:
• Enter https://192.168.0.1 into the address bar.
NOTE: The LAN-connected computer must have an IP address in the same
network range (192.168.0.xxx) as the remote console manager. If this is not
convenient, you can use the ARP Ping command to set the IP address (refer
to the user manual for details). The remote console manager also has its
DHCP client enabled by default, so it will automatically accept any network
IP address assigned by any DHCP server on your network—and will then
respond at both 192.168.0.1 and its DHCP address.
Log in using the default system user name: root, and the default
password: default. A Welcome screen listing the basic configuration steps
is displayed.
Select “System: Administration,” enter and confirm a new system
password, and click “Apply.”
Figure 2. System: Administration screen.
To assign your remote console manager a static IP address or to
permanently enable DHCP, select “System: IP” then “Network Interface”
and check “DHCP” or “Static” for configuration method.
NOTE: By default, only HTTPS and SSH access is enabled to the Remote
Console Manager itself. Use Service Access menu on System: Firewall to
change this, and to change access privileges for connected serial and
network devices. Similarly, use the Forwarding & Networking menu to permit
remote IP access to devices on Network or Management LAN.