Filter
Top Products
10
11
preCauTIOns
Wait at least 20 minutes after drinking, eating or smoking before 1.
testing. Not observing this waiting period can cause inaccurate
readings and damage the sensor.
Do not blow smoke, food, or liquids into the BACTRACK as this 2.
will damage the sensor.
Do not test in areas with strong winds, smoke, or in an area 3.
where a large amount of alcohol is being consumed.
Replace the two AA batteries when the battery indicator icon 4.
reaches one bar.
Send your tester in for periodic calibration service as required. 5.
(See calibration).
The BACTRACK Breathalyzer is designed to be used in a tem-6.
perature range of 50-104 °F (10-40 °C). Operation of the unit
in temperature ranges above or below this range may affect the
accuracy of results.
Avoid testing in the presence of any substances that contain 7.
methyl alcohol, isopropyl alcohol or acetone. These substances
may interfere with the results of the test.
You cannot use the results of this product in court.8.
Do not use the BACTRACK as a tool to determine whether you 9.
should operate a motor vehicle or equipment, or perform any
other dangerous act.
Do not drink and drive. Always have a designated driver when 10.
alcohol is being consumed.
speCIfICaTIOns
Dimensions 2.3 x 4.8 x 0.8 inches
(5.8 x 12.2 x 2.2 cm)
Weight 4.2 oz (119 g)
with mouthpiece and batteries
Sensor
Technology
Advanced semiconductor
Detection Range 0.000 – 0.400 %BAC
Test Count Displays total number of tests performed
Power Supply Two AA alkaline batteries, included
Battery Life Approximately 300 tests
Warm Up Time 10-30 seconds, depending on last use
Response Time 3 seconds
Sensor
Accuracy
+/- 0.01 %BAC @ 0.02 %BAC
Operating
Temperature
50-104 °F (10-40 °C)
This device has been tested using NHTSA/DOT procedures. In
this testing, the accuracy of this device was established at Blood
Alcohol Concentrations (BAC) of 0.008 and 0.032, but not at
greater concentrations. Additional laboratory testing has been
performed at concentrations ranging from 0.00 – 0.40% BAC.