Filter
Top Products
®2002 Directed Electronics, Inc.
14
To De-activate:
1. Press the button for one to two seconds.
2. The siren will shut off and the indicator lights will stop flashing.
If you wish to arm the alarm system but leave a window or sun-
roof open or a pet or passenger inside the vehicle, you will need
to bypass the Ultrasonic Sensor and any optional sensors by fol-
lowing the procedure noted below:
1. Arm the alarm with the button.
2. At anytime after the alarm system has been armed, press the
and buttons together.
3. To indicate sensor(s) bypass the indicator lights flash once.
NOTE: The next time the alarm system is armed the sensors will be re-
enabled automatically.
You should place your system in Protected Valet Mode whenever
your vehicle is being fueled or washed, or whenever the passive
Immobilisation or arming is not required for a short period. The
Valet PIN code number for your system is noted on the back of this
guide.
Note: To change your PIN code refer to How to Change Your PIN Code sec-
tion of this guide.
Protected Valet Mode
Sensor Bypass