Filter
Top Products
9
Overheating Alarm Function:
If the unit is heated without water, then the overheating alarm signal will flash on the display screen. An
“Er…” error message will be displayed on the screen. In such case the power supply of heating process
is cut off. Check the water supply and reset the heating.
To get hot water:
? Slide safety button on faucet up.
? Continue holding safety button while pushing in hot water faucet as long as water is being
dispensed.
? Once released, the safety button will return to the original position.
Cup Dispenser
A cup dispenser may be installed by using the mounting holes (covered with plastic caps) located near
the top of the right side panel of the cooler. The cup dispenser comes equipped with a mounting bracket
and screws and may be ordered by completing the enclosed order form provided with your instruction
manual.
CARE AND MAINTENANCE
? Wash the inside of the reservoir with a warm water and baking soda solution. The solution should be
about 2 tablespoons of baking soda to a quart of water. (Turn off the hot water function).
? The drip tray and water faucets should be cleaned with mild detergent and warm water.
? At regular intervals or once a month inspect the coils located across the back of the dispenser.
Vacuum accumulation of dust or clean it with a hard brush.
TAKING DISPENSER OUT OF SERVICE
? If the water dispenser will not be used for a long period of time, unplug the power cord from the wall
outlet.
? Turn off the hot water.
? Drain the water through the faucets.
? Drain the water from the tanks by removing the plug from the back of the dispenser.
? Unit should NOT be transported on the units side. Place it upright if possible and cover it with a
blanket.
WARNING—THE WATER COMING OUT OF THE BACK MAY BE SCOLDING HOT.
NOTE:
THE HOT WATER FAUCET HAS A CHILD-SAFETY GUARD ATTACHMENT.