Filter
Top Products
P. 4 User Guide CT-3360
To enable Idle Mode, press and hold the LOCK, UNLOCK or START/STOP button on your remote
transmitter while the engine is running.
Note: When enabling Idle Mode, pressing LOCK or UNLOCK will automatically unlock the
doors.
The parking lights will come ON. Remove the key, exit the vehicle and lock the doors (if
desired). Pressing the TRUNK button at this point will lock all Doors and activate Idle Mode.
The engine will continue running and will turn itself OFF when the pre-programmed run time
expires (see Step 6 of the “Setting the system to Ready Mode” section on p. 2).
Valet Mode
Ignition Valet
The system can be placed in Valet Mode to disable the remote starting capabilities. If the
vehicle needs to be serviced, or if you park it indoors, Valet Mode will prevent the engine
from being accidentally started by remote control.
To ENTER Valet Mode
1. With the key in the Ignition switch, turn the key to the ON (RUN/IGNITION) and then OFF
positions 5 times within 10 seconds.
2. The Parking Light will flash 3 times indicating the Module is now in Valet Mode.
The LED will turn ON solid.
To EXIT Valet Mode
1. With the key in the Ignition switch, turn the key to the ON (RUN/IGNITION) and then OFF
positions 5 times within 10 seconds.
2. The Parking Light will flash twice indicating the Module is now out of Valet Mode.
The LED will turn OFF.
Valet Mode using the Valet Button
(If installed)
To put the system into Valet Mode:
1. Turn the key to the IGNITION ON (RUN) position.
2. Press (for at least 1 second) and release the Valet Button. The L.E.D. will come ON.
To take the system out of Valet Mode:
1. Turn the key to the IGNITION ON (RUN) position.
2. Press (for at least 1 second) and release the Valet Button. The L.E.D. will go OUT.
The Valet button can only be used if the vehicle keys are in the IGNITION ON (RUN) position.
Panic Mode
Note: Panic mode can only be activated if the horn has been adequately configured
by your installer.
In an emergency situation, you can activate Panic Mode using the LOCK or UNLOCK button.
This will:
• shut down the engine,
• unlock the doors (with the UNLOCK button)
• or lock the doors (with the LOCK button),
• disarm the Starter Kill and
• activate the horn for 30 sec.
Note: See the description of the Starter Kill option later in this Guide.
To activate Panic Mode:
• Press and hold the UNLOCK button for approximately 3 sec. until the sound signal starts
and the parking lights flash: this will unlock the doors before the sound signal starts.