Filter
Top Products
User Guide P. 5
Retain Accessory Output
Retain Accessory output is activated as soon as key is turned to the ON position. When the key
goes from ON to OFF position, the accessory output stays ON and a countdown period of 10
minutes is set. The output is turned OFF after 10 minutes or if a door is opened anytime during the
countdown period.
Note: The Accessory Output is also turned off while starting the car.
System LED Flash Rate
The LED will display the status of the system, to indicate if the starter kill is armed or disarmed.
The LED will also indicate if the system is in valet mode or not (See “Valet operation” below.)
The following are LED conditions:
LED State System Status Mode
OFF Starter kill Disarmed Regular operation
ON Solid Starter kill Disarmed Valet Mode
Flashing slowly Starter Kill armed Regular operation
Flashing quickly System is in rearming sequence Passive arming Mode
Valet Operation
The unit can be placed into alarm valet mode to stop alarm conditions or to disable the alarm
functions and the anti-theft starter kill feature. While a vehicle stands in alarm valet mode, Panic
mode and door locking / unlocking functions are still operational.
This system can remotely be placed in or out of valet mode: it is not necessary to access the
vehicle.
Enabling the Alarm Valet
1. Turn the key to the RUN position.
2. Within 5 sec. press and hold the valet button for about 3 seconds.
3. The parking lights will flash 3 times to indicate that the system has entered valet mode.
4. Release the valet button and turn the key to OFF position
5. The LED on the antenna will come on and stay lit to indicate that the alarm valet mode
is enabled.
Disabling the Alarm Valet
1. Turn the ignition to the RUN position.
2. Within 5 sec. press and hold the valet button for about 3 seconds.
3. The parking lights will flash twice to indicate that the system is out of valet mode.
4. Release the valet button and turn the key to OFF position
5. The LED will go out to indicate that the alarm valet is disabled.
Remote Valet Operation
The system can be placed in or out of valet mode through the remote control. This means that the
user does not have to enter the vehicle or switch the key to the RUN position to get in or out of
valet mode.
To remotely place the system in or out of valet mode:
• Press and hold
+ buttons simultaneously for 3 seconds on the transmitter; the
system will toggle in and out of valet mode:
o Getting into valet mode, the parking lights will flash 3 times, the LED will
come on and remain lit.
o Getting out of valet mode, the parking lights will flash twice, the LED will go
out.