Filter
Top Products
AS-6205 SH User Guide P. 4
x Turn the ignition key to the IGNITION ON (RUN) position. (Do not turn the key to the START
position while the engine is running. This will cause the starter motor to re-engage.)
x Press the brakes to disengage the remote starter unit.
You are now ready to drive off.
Idle Mode
This feature allows you to remove the key from the ignition and leave the vehicle running
for its pre-programmed run time while you are away from your vehicle. This feature is
handy if you need to stop for a quick delivery, or at a convenience store.
To enable the Idle Mode:
1. Press and hold LOCK, UNLOCK or START on your transmitter while the engine is running.
2. The parking lights will come ON.
3. Remove the key, exit the vehicle;
x Press the LOCK button if you need to lock the doors while the engine is running.
Caution: Do not leave children or pets unattended in a car running in Idle Mode.
Valet Mode
The system can be placed in Valet Mode to disable the remote starting capabilities. If the
vehicle needs to be serviced, or if you park it indoors, the Valet Mode will prevent the
engine from being remote-started accidentally.
To put the system into Valet Mode:
1. Turn the key to the IGNITION ON (RUN) position.
2. Within 3 sec. press the Valet button and release it. The LED will come ON. (The
system is in Valet Mode.)
To take the system out of Valet Mode:
1. Turn the key to the IGNITION ON (RUN) position.
2. Within 3 sec. press and release the Valet button. The LED will go OUT. (The system
is out of Valet Mode.)
The Valet button can only be used if the ignition key is in the
IGNITION ON (RUN) position.
Ignition Valet
The system can be placed in Valet Mode to disable the remote starting capabilities. If the
vehicle needs to be serviced, or if you park it indoors, Valet Mode will prevent the engine
from being accidentally started by remote control.
To ENTER Valet Mode
1. With the key in the Ignition switch, turn the key to the ON (RUN/IGNITION) and then OFF
positions 5 times within 10 seconds.
2. The Parking Light will flash 3 times indicating the Module is now in Valet Mode. The
LED will turn ON solid.
To EXIT Valet Mode
1. With the key in the Ignition switch, turn the key to the ON (RUN/IGNITION) and then OFF
positions 5 times within 10 seconds.
2. The Parking Light will flash twice indicating the Module is now out of Valet Mode.
The LED will turn OFF.