Filter
Top Products
User Guide P. 5
1. Turn the key to the IGNITION ON (RUN) position.
2. Press (for at least 1 second) and release the Valet Button. The L.E.D. will come ON.
To take the system out of Valet Mode:
1. Turn the key to the IGNITION ON (RUN) position.
2. Press (for at least 1 second) and release the Valet Button. The L.E.D. will go OUT.
The Valet button can only be used if the vehicle keys are in the
IGNITION ON (RUN) position.
Panic Mode
Note: Panic mode can only be activated if the horn has been adequately configured
by your installer.
In an emergency situation, you can activate Panic Mode using the
LOCK or UNLOCK button.
This will:
• shut down the engine,
• unlock the doors (with the UNLOCK button)
• or lock the doors (with the
LOCK button),
• disarm the Starter Kill and
• activate the horn for 25 sec.
Note: See the description of the Starter Kill option later in this Guide.
To activate Panic Mode:
• Press and hold the UNLOCK button for approximately 3 sec. until the sound signal starts
and the parking lights flash: this will unlock the doors before the sound signal starts.
• Or press and hold the LOCK button for approximately 3 seconds until the sound signal
starts and the parking lights flash: this will lock the doors before the sound signal
starts.
Panic Mode will automatically shut down after 25 sec.
Note: To stop Panic Mode before the end of its delay, press the
LOCK or UNLOCK button
until the sound signal stops.
Cold Weather Mode
When Cold Weather Mode is active, the engine starts every 2 hours and runs for 3 minutes
(or for 8 or 18 minutes with Diesel engines); the routine goes on for a period of 24 hours.
To enter Cold Weather Mode:
• With the vehicle already in Ready Mode, press and hold the START/STOP button until
the parking lights flash 3 times.
To exit Cold Weather Mode, do any one of the following:
• Open the hood.
• Start the engine using the remote control.
• Turn the ignition key to the IGNITION ON (RUN) position.
• Press and hold the START/STOP button for 3 seconds
(until the parking Lights flash once)
• Set the vehicle to Valet Mode.
Advanced Features: Installation-programmable Options
The remote car starter was designed with flexibility and OEM integration in mind. With its
programmable options, this unit can single-handedly control nearly any electrical system in
your vehicle.
Note: The programming of these features should be left to a professional. Changing any
one of the settings may adversely affect the operation your Remote Car Starter.