Filter
Top Products
P. 4 User Guide AS-1414/AS-1424
To ENTER Valet Mode
1. With the key in the Ignition switch, turn the key to the ON (RUN/IGNITION) and then OFF
positions 5 times within 10 seconds.
2. The Parking Light will flash 3 times indicating the Module is now in Valet Mode.
The LED will turn ON solid.
To EXIT Valet Mode
1. With the key in the Ignition switch, turn the key to the ON (RUN/IGNITION) and then OFF
positions 5 times within 10 seconds.
2. The Parking Light will flash twice indicating the Module is now out of Valet Mode.
The LED will turn OFF.
Valet Mode Using the Valet Button
(Available only of the plug-in Valet switch is installed)
To put the system into Valet Mode:
1. Turn the key to the IGNITION ON (RUN) position.
2. Press (for at least 1 second) and release the Valet Button. The L.E.D. will come ON.
To take the system out of Valet Mode:
1. Turn the key to the IGNITION ON (RUN) position.
2. Press (for at least 1 second) and release the Valet Button. The L.E.D. will go OUT.
The Valet button can only be used if the vehicle keys are in the
IGNITION ON (RUN) position.
Cold Weather Mode
When Cold Weather Mode is active, the engine starts every 2 hours and runs for 4 minutes
(or for 20 minutes with Diesel engines); the routine goes on for a period of 24 hours.
To enter Cold Weather Mode:
x Press and hold the START/STOP button until the parking lights flash 3 times.
To exit Cold Weather Mode, do any one of the following:
x Open the hood.
x Start the engine using the remote control.
x Turn the ignition key to the IGNITION ON (RUN) position.
x Press and hold the START/STOP button for 3 seconds
(until the parking Lights flash once)
x Set the vehicle to Valet Mode.
Advanced Features
Remote Door Locks
If your system was installed with the Remote Door Locks option, you will have the
convenience of remote keyless entry.
To LOCK your doors and ARM the Starter Kill:
1. Press and hold the LOCK button for approx. 1 sec.
2. The parking lights will flash once and the L.E.D. will flash slowly to confirm that the
doors have been locked and that the Starter Kill feature is enabled if it was
installed.
To UNLOCK your doors and DISARM the Starter Kill:
1. Press and hold the UNLOCK button for approx. 1 sec.
2. The parking lights will flash twice and the L.E.D. will go out to confirm that the
doors have been unlocked and that the Starter Kill feature is disarmed if it was
installed.
Note: If installed and configured in Passive Mode at installation, the Starter Kill feature will
rearm automatically 60 seconds after the doors are unlocked. For that reason, you may
have to unlock your doors a second time if some time elapses before you actually start
the engine.