Filter
Top Products
P. 6 User Guide
Advanced Features: Installation-programmable options
Note: The programming of these features should be left to a professional. Changing any one of the
settings may adversely affect the operation of the module.
Arming the Starter Kill
Note: It can only be activated if button Ι is programmed as LOCK or UNLOCK button.
If installed, the Starter Kill can be programmed to arm in Active Mode (will not arm automatically) or in
Passive Mode (will arm automatically).
• To disarm the Starter Kill in Active or Passive Mode, press the Ι button on the transmitter. The
parking lights will flash twice. (If Remote Door Locks were installed, this will also unlock the doors.)
In Passive Mode, the system will automatically rearm 1 or 3 minutes after the doors were unlocked.
• To arm the Starter Kill in Active or Passive Mode, press the Ι button on the transmitter. The parking
lights will flash once. (If Remote Door Locks were installed, this will also lock the doors). In Passive
Mode, the system will automatically arm 1 or 3 minutes after the engine is shut down.
Remote Door Locks
Note: It can only be activated if button Ι is programmed as LOCK or UNLOCK button.
If your system was installed with the Remote Door Locks option, you will have the convenience of
remote keyless entry.
To lock your doors and arm the starter kill (if installed):
1. Press and hold the Ι button for approx. 1 sec.
2. The parking lights will flash once to confirm that the doors have been locked and that the Starter
Kill feature is enabled if it was installed.
To unlock your doors and disarm the starter kill:
1. Press and hold the Ι button for approx. 1 sec.
2. The parking lights will flash twice and the LED. will go out to confirm that the doors have been
unlocked and that the Starter Kill feature is disarmed if it was installed.
Note: If installed and configured in passive mode at installation, the starter kill feature will rearm
automatically 60 seconds after the doors are unlocked. For that reason, you may have to unlock
your doors a second time if some time elapses before you actually start the engine.
Ignition-controlled Door Locks Option
This is an added security feature. If your remote starter was installed with the ignition-controlled door
locks option, the doors will automatically lock as soon as the key is turned to the
IGNITION ON (RUN)
position while the brakes are pressed. The remote car starter will also lock any door that was unlocked
and opened (then closed) the next time the break pedal is pressed. When the key is turned to the
OFF
position, the doors will automatically unlock.
Secure Lock Option
(Only for certain vehicles.) Before it can remote start your vehicle, the remote starter must first disarm
the factory security system. The secure lock feature may be required on certain vehicle models with
factory security systems that automatically unlock the doors when the security system is disarmed.
To keep your vehicle protected when the factory security system is disarmed for a remote start, secure
lock will relock your doors as soon as the vehicle has started. Once the engine run cycle ends, secure
lock will rearm your factory security system.
Remote Trunk Release Option
If your system was installed with the Remote Trunk Release, you can open your trunk by pressing the
Ι & ΙΙ buttons (simultaneously) on the remote transmitter. Vehicles must have an electric trunk switch
or a remote trunk button on the vehicle’s OEM Transmitter for this option to be compatible with the
module.