Filter
Top Products
User Guide P. 3
Remote Starting Your Vehicle
If your vehicle has an automatic transmission, simply press the Ι button to remote start or the
ΙΙ button to stop your vehicle. Please see “Remote starting” below.
Warning: If your vehicle has an automatic transmission and the parking lights flash 15 times after
pressing the ΙΙ button, please see your installer as programming will have to be modified.
Setting Your Vehicle Into Ready Mode
If your vehicle has a manual transmission you must read the following indications. In order to start the
vehicle by remote, the unit must first be set to Ready Mode. If the unit is not set to Ready Mode, it
cannot remote start the vehicle.
Please note that Ready Mode can be enabled by the remote or the handbrake, depending on the
option that was selected by your installer. Therefore, you must follow the appropriate procedure
between the two described below in order to set your vehicle into Ready Mode.
Once the system is set to Ready Mode, the vehicle can be remote started and stopped at any time. The
system will exit Ready Mode if a door, the hood or the trunk is opened, if the brake pedal is pressed, if
the parking brake is disengaged or if the ignition key is turned to the
IGNITION ON (RUN) position.
To set the system to Ready Mode:
If Ready Mode is enabled by remote If Ready Mode is enabled by handbrake
1. Ensure that all the doors, hood and trunk are closed. Make sure that the gear selector is in the neutral
position.
2. With the engine already running, apply the
parking brake once and release the brake
pedal.
Make sure to release the brake pedal.
2. With the engine already running, apply the
parking brake twice and release the brake
pedal.
Make sure to release the brake pedal.
The parking lights will flash 3 times
quickly and remain lit.
Skip to step 4.
3. Within 20 sec. of engaging the parking brake,
press and hold Ι or ΙΙ on the transmitter.
The parking lights will flash 3 times
quickly and remain lit.
-
4. Remove the key: the engine will continue running.
5. Exit the vehicle and close all doors, hood and trunk.
6. Press for approx. 1 second either button: Ι or ΙΙ.
Remote Starting
Press the Ι button for approx. 1 second. The parking lights will come ON and the transmitter will beep
once to inform you that the remote starter has received your signal. Approximately 5 seconds later, the
engine will start. The transmitter will beep 3 times and the parking lights will remain
ON during the pre-
programmed run time of the engine.
If the vehicle does not start at the first attempt, the system will shut down. If your vehicle is equipped
with an automatic transmission, there will be 3 start attempts before the system gives up.
Driving Off
With the vehicle running under remote start, press the button Ι to disarm the security system (if button
Ι is programmed as
LOCK or UNLOCK button). Enter the vehicle and do the following:
1. Turn the ignition key to the IGNITION ON (RUN) position. (Do not turn the key to the CRANK position
while the engine is running. This will cause the starter motor to re-engage.)
2. Press the brake pedal to disengage the remote starter unit.
You are now ready to drive off.