Filter
Top Products
P. 4 User Guide
To EXIT Valet Mode
1. With the key in the Ignition switch, turn the key to the ON (RUN/IGNITION) and then OFF
positions 5 times within 10 seconds.
2. The Parking Light will flash twice indicating the Module is now out of Valet Mode.
The LED will turn OFF.
Valet Mode Using the Valet Button
(Available only of the plug-in Valet switch is installed)
To put the system into Valet Mode:
1. Turn the key to the IGNITION ON (RUN) position.
2. Press (for at least 1 second) and release the Valet Button. The parking lights will
flash 3 times and then turn the key to IGNITION OFF position. The L.E.D. will come on.
To take the system out of Valet Mode:
1. Turn the key to the IGNITION ON (RUN) position.
2. Press (for at least 1 second) and release the Valet Button. The parking lights will
flash twice and the L.E.D. will go OUT.
The Valet button can only be used if the vehicle keys are in the
IGNITION ON (RUN) position.
Panic Mode
Note: Panic mode can only be activated if the horn has been adequately configured
by your installer and if button Ι is programmed as LOCK or UNLOCK button.
In an emergency situation, you can activate panic mode using the
Ι button. This will:
• shut down the engine,
• unlock the doors (with the Ι button)
• or lock the doors (with the Ι button),
• disarm the Starter Kill and
• activate the horn for 25 sec.
Note: See the description of the starter kill option later in this Guide.
To activate panic mode:
• Press and hold the Ι, button for approximately 3 sec. until the sound signal starts and
the parking lights flash: this will unlock the doors before the sound signal starts.
• Or press and hold the Ι, button for approximately 3 seconds until the sound signal
starts and the parking lights flash: this will lock the doors before the sound signal
starts.
Panic Mode will automatically shut down after 25 sec.
Note: To stop panic mode before the end of its delay, press the
Ι button until the sound
signal stops.
Cold Weather Mode
When Cold Weather Mode is active, the engine starts every 2 hours and runs for 3 minutes
(or for 20 minutes with Diesel engines); the routine goes on for a period of 24 hours.
To enter Cold Weather Mode:
• Press and hold button ΙΙ until the parking lights flash 3 times.
To exit Cold Weather Mode, do any one of the following:
• Open the hood.
• Start the engine using the remote control.
• Turn the ignition key to the IGNITION ON (RUN) position.
• Press and hold button ΙΙ for 3 seconds
(until the parking Lights flash once)
• Set the vehicle to Valet Mode.