Filter
Top Products
3
CHANGING THE BATTERY IN YOUR TRANSMITTERS
XT-33: This transmitter uses two (2) 3-volt lithium ion batteries
(#CR2016) that are sandwiched together with the (+) side facing upward.
To replace the battery, you will need to use a small flat blade screwdriver.
Locate the small notch on the lower right side of the transmitter case
next to the key ring. Using the flat blade screwdriver, carefully pry the
top case from the bottom case. It should snap apart after breaking the
seal. Before removing the batteries note the direction of the positive (+)
terminal. Place the new batteries in exactly the same manner, being
careful not to bend or damage the contact terminal. Snap the cases
back together and then test the transmitter to insure it arms and disarms
the alarm.
XT-65: This transmitter uses one 3-volt battery. Please use the
procedure above to replace this battery.
XT-65 Extended XT-33 Standard Remote
Range Sliding Cover remote
CR2032
3-Volt Battery
ACTIVE LOCK & ARM:
1. Press button on the transmitter.
2. The Siren will chirp once and parking lights will flash once indicating
that the system is now active. The vehicle doors will lock upon
activating only when interfaced with the factory keyless entry system.
SILENT ARMING / DISARMING: Pressing the + buttons
together on the transmitter will lock or unlock your system, No chirp
sound will be heard. Lock / unlock confirmation will be seen through the
vehicle’s parking lights only.
(2) CR2016
3-Volt Batteries