Filter
Top Products
5
TRIGGER THE SYSTEM
When armed, your vehicle is protected as follows:
1. Light impacts will trigger the warn-away signal. A long chirp from siren/horn.
2. Heavy impacts / Doors open / Hood open / Trunk open / Turning on the ignition switch- All will
trigger the programmed sequence.
The starter disable relay (if installed) prevents the vehicle’s starter from cranking. The siren and
parking lights will turn on to alert of an intrusion for 30 seconds. Then the siren will stop and
automatically reset and re-arm. If any of the sensors or detectors are still active, the alarm
system will sound a maximum of three-30 second cycles.
Trunk/Hood
Trigger
Doors
Trigger
Shock
Sensor Trigger
Ignition
Trigger
Warn-away Trigger
Clear the Flash Icon and Melody Sound: Cycle ignition then press the
button first, within 3 seconds press and buttons at t
he same
time. It will clear the
flash icon and melody sound on the LCD screen
transceiver
NOISE ABATEMENT CIRCUIT:
Your system has “Noise Abatement Circuit”. It prevents annoying repetitive trigger sequences
due to faulty door pin switches or environmental condition such as thunder, jackhammers, airport
noise, etc. Here’s how “Noise Abatement Circuit” works: The alarm triggers five times. Each
time, the same sensor or switch is triggering the alarm. “Noise Abatement Circuit” will interpret
this pattern of triggers as false alarm. After the fifth trigger, “Noise Abatement Circuit” ignores, or
bypasses, that sensor or switch until the other sensor or switch is trigger.
“Noise Abatement Circuit” covers doors (Hood/Trunk) differently: If the alarm is triggered by an
open door for three full cycles, the doors will be bypassed until the trigger ceases.
DRIVER PAGING (For two-way transmitter operation only)
It is useful in the event that someone wants to page the driver of the parked vehicle. With the
ignition switch in the “off” condition, press the
button on the window mount antenna once to
page the driver, one chirp sound shall be emitted from the vehicle and the paging melody
continues sounding from your Remote LCD Transmitter and “ ” indication flashes o
n the LCD
screen.