Filter
Top Products
4
PANIC FUNCTION:
The transmitter can be used as a remote panic switch to manually trigger the alarm in case of
emergency.
1. Press and hold the
button on the transmitter for 3 seconds. The alarm will immediately
sound.
2. To stop the alarm, press and hold the
or
button on the transmitter, the panic mode
will be turned off immediately.
3. If the button is not pressed, the alarm will automatically stop after 30 seconds.
Note: If the H3/6 Gray Wire is not a Trunk release Output, (See Alarm Feature III-2
Programming), Press and hold the
button on the transmitter for 3 seconds. The alarm will
immediately sound.
TRIGGER THE SYSTEM
When armed, your vehicle is protected as follows:
1. Light impacts will trigger the warn-away signal. A long chirp from siren/horn.
2. Heavy impacts / Doors open / Hood open / Trunk open / Turning on the ignition switch- All
will trigger the programmed sequence.
The starter disable relay (if installed) prevents the vehicle’s starter from cranking. The siren and
parking lights will turn on to alert of an intrusion for 30 seconds. Then the siren will stop and
automatically reset and re-arm. If any the sensors or detectors are still active, the alarm system
will sound a maximum of six-30 second cycles.
IGNITION CONTROL DOOR LOCKS. (See Feature II – 3 Programming.).
If the vehicle’s door locks have been interfaced to the security system, the system will
automatically lock the vehicle's doors when the ignition is turned “ON” and /or unlock the
vehicle’s doors when the ignition is turned “OFF”.
TRUNK RELEASE. (See Feature III – 2 Programming.).
Press and hold
button on transmitter for two seconds to remote control the trunk release
or other electric devices.
CAR LOCATOR
Press the
button on the transmitter to active car locator function. The siren will chirp 6
times. The parking light will flash 12 times, allowing you to easily locate your car.
P. PATHWAY ILLUMINATION (See Feature III - 3 Programming.)
When disarming the security system, the vehicle’s parking lights will stay on, illuminating a
pathway to the vehicle. The vehicles parking lights will stay on for 30 seconds or until the
vehicle’s ignition is turned to the “ON” position.
ALARM OPERATING CONDITION:
Function
Siren Parking
Lights
LED Doors Starter
Disable
Pager
Option
1. Arm 1 Chirp 1 Flash Slow flash
Locking On
2. Disarm 2or4
Chirps
2 or 3
Flashes
Off or
Fast flash
Unlocking Off
3. Trigger Alarming Flashing Slow flash
On On
4. Panic Alarming Flashing Slow flash
Locking On