Auto Page CPX-3600 Automobile Alarm User Manual


 
DISARMING WITHOUT A TRANSMITTER
The Override function may be used if the remote transmitter is lost or
inoperative.
1. Enter the vehicle and turn the ignition switch to 'ON’ position. (Alarm
will sound.)
2. Within 10 seconds push and release the valet switch
The alarm will stop sounding and enter the disarm mode. You can now
start and operate the vehicle normally.
VALET MODE:
The valet switch allows you to temporarily bypass all alarm function,
eliminating the need to hand your transmitter to parking attendants or
garage mechanics. When the system is in valet mode, all alarm functions
are bypassed, however, the remote panic feature and remote door locks
will remain operational.
Enter Valet Mode:
1. Turn the ignition to “ON” position.
2. Push and hold valet switch for 2 seconds or until the LED turns on.
The LED will remain on as long as the system is in 'valet mode'.
Exit Valet Mode:
1. Return to normal operation, turn ignition 'ON'.
2. Push and hold valet switch for 2 seconds; the LED will turn off
indicating the system is exiting the valet mode.
PANIC FUNCTION:
The transmitter can be used as a remote panic switch to manually trigger
the alarm in case of emergency.
1. Press and hold the
button on the transmitter for 3 seconds. The
alarm will immediately sound.
2. To stop the alarm, press and hold the
or
button on the transmitter,
the panic mode will be turned off immediately.
3. If the button is not pressed, the alarm will automatically stop after 30
seconds.
TRIGGER THE SYSTEM
When armed, your vehicle is protected as follows:
1. Light impacts will trigger the warn-away signal. A long chirp from
siren/horn.
2. Heavy impacts / Doors open / Hood open / Trunk open / Turning on the
ignition switch- All will trigger the programmed sequence.
The starter disable relay (if installed) prevents the vehicle’s starter from
cranking. The siren and parking lights will turn on to alert of an intrusion for
30 seconds. Then the siren will stop and automatically reset and re-arm. If
any the sensors or detectors are still active, the alarm system will sound a
maximum of six-30 second cycles.
PATHWAY ILLUMINATION (OPTIONAL)
When disarming the vehicle, the parking lights will stay on illuminating your
pathway to the vehicle. The parking lights will stay on for 30 seconds or
ignition “On”, whichever comes first?
6